Cool Down Sequence for Camera

Voyager
#1

Today I was setting up the Profile for my new camera. This camera is a cooled camera, first time
for me. I set the cool down time in the Profile to 3 minutes. When I disconnected my equipment
I did not see a cool down period, everything disconnected and seemed fine.

Not an issue today as the set temperature was 0 and the outside temperature was -3. Is Voyager
smart enough to see the temp difference is small enough not to worry about? If so impressive.

Bob Parry
Chilliwack Observatory

#2

If you disconnect setup … Voyager cannot manage your camera.
If you want to safe disconnect start before warmup, manually or from DragScript, and when finished disconnect all. If you are in full automation you also have good night action, more sophisticated.

All the best
Leonardo Orazi