Taking Bias Frames

Just want to take some Bias Frames and I set the Sequencer up for this. But when I hit the Sequencer button I get the message “Error:Insert coords in J200 format”

How do I get past that?

Think I found the answer:

Now go through the tabs in the Sequence definition and turn off anything that would be needed if you were shooting a light frame but is not needed for calibration frames:
a) On Start tab: Uncheck “Point Target on Start” and “Inject Focus on Start”
b) Plate Solving: Check “Disable Plate Solving”
c) Meridian flip: Select “Do Not Manage” from the drop-down
d) Guide/Dithering: Uncheck the boxes next to “Calibrate Guide” and “Guiding” (or select No Guider in your profile setup)
e) Focus: Uncheck any selections to do an autofocus action

Best solution its simple using the DragScript precompiled, or clone your profile and changing mount with an ASCOM simulator.

All the best
LO